Step 5

Install ZeroWobble Hitch Mount

Viewing instructions for Max, Max+


(A.) Insert ZeroWobble Bolt Through Hitch Pin Hole

Put the washer on the head of the bolt and insert it through the hitch pin hole and receiver tube.

(B.) Thread ZeroWobble+ Nut to Bolt

Thread the ZeroWobble+ barrel nut with handle onto the bolt.

(C.) Tighten Bolt, Secure ZeroWobble+ Handle

Tighten bolt & secure ZeroWobble+ handle (by hand or lock it in a position for example against your hitch). Continue tightening until it stops.

(D.) Ensure Nut Recesses into Hitch Pin Hole

If needed, keep tightening until the barrelĀ nut recesses into the hitch pin hole (as shown by the blue area in the image above). You can also validate this as the end of the bolt should be virtually flush with the back of the nut. This is critical to eliminating any rotational movement.

For a PDF/printable manual for all MTX carriers, click here.